When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey There, New thread for a new issue. I was attempting to remove the ignition pick-up coil so I could replace the dime size camshaft position sensor, and when I got the pick-up coil to come up, the small camshaft position sensor thing went flying. Now I have no idea where or how this sensor is supposed to go back in the distributor. Anybody, please help. This truck is becoming a huge thorn in my side.
Did you buy the new part? If you did you should have a disc about 3+ inches across with 2 or 3 wires coming out of it 12 inches or so long with a connector. You have to take the rotor off to lift the plate out. I don't remember if there is a screw holding it down.
Yes, and I bought that. It’s on the truck. My sister was going to put the wires back on the distributor and we had it out because where firing order in book has arrow pointing and says front of truck with the two rows of plugs with distributor in back. She seems to think it’s wrong and was going to proceed to turn the book around how she thinks it should go so I cussed her out and told her to step away from the vehicle. I’ll do it later when she’s not here to aggravate me. She needs to hurry up and go back to California. 🙃
Yes, I know that. I know more than most women and some men.😉 Got everything put together. Truck started and ran for about a minute and died. Started it again and it ran for less than a minute and died. It still needs something.