I just got HIDs installed in My 2003 Durango SXT
I took out the old headlights and replaced them with the
Headlights you see below. Now, I ran into some problems because the
the old headlights took 9007 bulbs and the HID came with 9007 bulbs but the Projector head lights came with slots for an H3 Bulb. Anyway, my question is:
When everything was hooked up one turn single wasn't needed (Durango has 2 on each side, I believe) the projector head light only needed one, one on each side now is just hanging in there. So now when I signal it blinks rapidly like it would if a bulb was blown. How can I stop that? Clip the wires? ground it...what?


Thanks

 

put a bulb into the empty socket

 

HID's came with a amp kit if I remember right.


As for your turn signal, IDK?

 

Did you check if the turn signal bulb has blown? If so, just tape the loose ones to the housing and there you go.

 

I love Duct Tape!......LMAO

 

post a pic with the installed...
and I can make a request...take pics of:
all lights off,
parking lights,
all lights on.