Broke the crankshaft position sensor off in the block...
#1
Broke the crankshaft position sensor off in the block...
I was in the process of replacing my crank sensor in my 4.7, and all of a sudden, it snapped off. It's about a quarter of an inch deep in the hole. Is there any way to get this out without dropping the oil pan and tapping it from behind?
#2
Shift:
If you have not already, soak the heck out of it with some good pentrating oil. Then, thread in a fairly coarse wood type screw of some type until you get a good firm bite.
Then work/wiggle it back and forth till it comes out. Might take some time, but if you can keep from pulling the oil pan, it will be worth it.
Don
If you have not already, soak the heck out of it with some good pentrating oil. Then, thread in a fairly coarse wood type screw of some type until you get a good firm bite.
Then work/wiggle it back and forth till it comes out. Might take some time, but if you can keep from pulling the oil pan, it will be worth it.
Don