NOT!
So, dropped everything to get pan off, ect.
4WD, so all that extra bracketry.
Had trouble getting axle back up, going over it all bracket 'slots' are not sliding down on through bolt above mount rubber.
Washered nut will go on just fine - so contained.
I loosened everything up and tried 'dropping' it all fast by jack, stayed at slightly lifted position.
The slotted ears just do not want to slide down to previous position.

Anyone else, got a suggestion?

 

Maybe try slightly loosening the mounts, then slotting it? If that doesn't work, the only thing I could think is that the motor isn't angled right, causing the holes to not line up