1st Gen Durango 1998 - 2003 Durango's

2000 Durango 4.7 Stalls when cold

Thread Tools
 
Search this Thread
 
  #11  
Old 12-19-2006 | 01:55 PM
hydrashocker's Avatar
hydrashocker
Hall Of Fame
Joined: Jun 2005
Posts: 14,228
Likes: 17
From: Riverton, UT
Default RE: 2000 Durango 4.7 Stalls when cold

NorcalDurango<-----It could be your IAC. Clean it and reinstall.

I am wondering if the problems that you guys are having is a bad MAP sensor.
 
  #12  
Old 12-19-2006 | 06:12 PM
steve05ram360's Avatar
steve05ram360
Hall Of Fame
Joined: Jan 2004
Posts: 12,829
Likes: 237
Default RE: 2000 Durango 4.7 Stalls when cold

ORIGINAL: hydrashocker

NorcalDurango<-----It could be your IAC. Clean it and reinstall.

I am wondering if the problems that you guys are having is a bad MAP sensor.
I was wondering how many posts i'd have to go thru before this showed up... I'm not sure how the 4.7's do it but it has to have a valve that lets enough air thru the TB to keep the idle up. that valve is either dirty or is going bad. when it's cold it will be sticking worse making the stalling worse.

my suggestion... go to www.hemitruckclub.com & download the service manual found on the left side of the page for an '03 or '04 ram. in there is the section for the 4.7 motor which is the same as what you have. find the TB & idle control valve and go from there. I'll bet that once you find it, if you put a blow dryer or heat gun prior to starting it when it's cold (heat it up) it wont stall. if that is the case, you found your problem.

 
  #13  
Old 12-19-2006 | 10:54 PM
PJ2's Avatar
PJ2
Registered User
Joined: Mar 2006
Posts: 34
Likes: 0
Default RE: 2000 Durango 4.7 Stalls when cold

Bad TPS sensor should malfunction at all temps. I would do basic tune up as base line, wires plugs, all filters etc. Clean throttle blades make sure they are closing all the way. Inspect linkage and check for vacuum leaks around manifold and hoses. Are you getting a check engine light? I would look at MAP sensor first. Shop around for price. I changed a TPS couple weeks ago that was 79 bucks at Pep Boys and 29 at Autozone. GO figure? Good Luck.
 
  #14  
Old 12-26-2006 | 06:05 PM
2000Durango47's Avatar
2000Durango47
Thread Starter
Joined: Nov 2006
Posts: 3
Likes: 0
From:
Default RE: 2000 Durango 4.7 Stalls when cold

I finally fixed it.It turned out to be the IDLE AIR CONTROL (IAC) MOTOR. The Mopar part number is 53030840. It is extremely easy to change and retails anywhere from $52.95 to $100.00 depending on where you buy it.


[IMG]local://upfiles/49390/5B6F1360C7394F7DA7133F12D50949A8.gif[/IMG]
 



Quick Reply: 2000 Durango 4.7 Stalls when cold



All times are GMT -4. The time now is 02:51 PM.