sorry for a possible repost

i just changed the headgausket on my car
now it wont start
i checked all the sensors
sounds like it wants to turn over but it doesnt
need help fast
any possible ground might be loose
i know thepass side and the front ground are on and tight
any help please

 

Double check ALL your connections to the starter. Does it crank at all and not turn over? Have you checked fuses at all?

 

fuses are all good, it was cranking, but now i think the starter went bad from plenty of attempts...i try jumpin it, tryed starting fluid, its getting spark (little flame in the throttle body lol) i dont know what to do, this car never gave me a hard time starting up before, just leaked alot of oil

also even if the starter was bad ( i need to hit it a few times) wouldnt it still start from the extra juice from the jump

it comes close to starting, sometimes i hear a weird quite burble sound from the engine

 

You set the timing right? Getting fuel pressure?

 

getting fuel pressure not to sure of the timing, but pretty sure its good (i had to get the head shaved) i made sure everything was tight

 

you might have broke the timing belt.

 

no i can see the belt spin, when someone trys to start it

 

update

swapped out the camshaft sensor with an extra i had, it wasnt it
i have a feeling it may be the crankshaft sensor, it went before, so i put a used one in
if i recall right, that cost about $100-$120 right?

 

I'm thinking it's timing.

 

anything else it could be, i think if it WAS the timing, it would still start, but it would either die out or run like crap