disk brakes and wing help?
#1
#2
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
we were just talking about this last week
https://dodgeforum.com/m_1316208/mpa...tm.htm#1316300
[sm=teetertooter.gif]
https://dodgeforum.com/m_1316208/mpa...tm.htm#1316300
[sm=teetertooter.gif]
#3
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
Here's what an srt4 spoiler on 1rst gen looks like
http://www.cardomain.com/ride/2937012
http://www.cardomain.com/ride/2937012
#4
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
ORIGINAL: 98 NEON SRT4
Here's what an srt4 spoiler on 1rst gen looks like
http://www.cardomain.com/ride/2937012
Here's what an srt4 spoiler on 1rst gen looks like
http://www.cardomain.com/ride/2937012
#5
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
Yeah the hood cowlis due to a saggy motor mount during the fitment stage of the install. It looksa lil differentin person. The next car will probably have a regular hood. To install the spoiler you'll have to notch out where the studs got through the trunk lid to fit a wrench in there. Oh yeah thanks for not callin the car"gay"
![Big Grin](https://dodgeforum.com/forum/images/smilies/biggrin.gif)
#6
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
did u build that hood out of ur stock SOHC hood? looks pretty good for a custom built hood and def. gives u the clearance u needed. i like the door panels too. a lot of srt swaps u see just have huge holes cut in the stock panels to make clearance for the dash....
#7
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
Yep that was a stock hood. We did all of the work ourselfs, except the window tint and welding the stainless steel cat in. Don't have a welder for stainless steel. The dash definately doesn't fit thestock neon door panels, or anything else for that matter. I think we'll probably start selling the fiberglass door panels like the one's used in the car. We just need to make a better mold so we can crank them out.