1st Gen Neon 1995 through 1999 Neons

how to run powerwire

Thread Tools
 
Search this Thread
 
Old Aug 19, 2008 | 01:08 PM
  #1  
RiceRocketEater's Avatar
RiceRocketEater
Thread Starter
|
Registered User
Joined: Jun 2008
Posts: 45
Likes: 0
From:
Default how to run powerwire

im installing 2 subs in the back of my neon

2 thinks just wondering how 2 pull up the pary in the in side of the door (in the rocker pannel area) dose the little back pieace come off

and how dose the back seet come out if some one has a diargram that would b great
 
Reply
Old Aug 19, 2008 | 06:50 PM
  #2  
12 volt's Avatar
12 volt
Record Breaker
Joined: Aug 2007
Posts: 1,797
Likes: 0
From: roswell New Mexico
Default

i ran my wire thru the rubber grommet that the engine wiring harness goes thru, then under the trunk opener.

the bottom of the back seat comes out by pulling on the front of it, yes it just pops out.
 
Reply
Old Aug 19, 2008 | 10:44 PM
  #3  
DOHCgarrett t3's Avatar
DOHCgarrett t3
Record Breaker
15 Year Member
Joined: Nov 2006
Posts: 1,791
Likes: 0
From: Detroit Michigan
Default

yep just give both a good yank and they come out. the car is built like a big lego set.
 
Reply
Old Aug 20, 2008 | 10:49 PM
  #4  
bigjo1990's Avatar
bigjo1990
Registered User
Joined: Jun 2008
Posts: 19
Likes: 0
Default

i ran a power wire through a rubber grommet under the carpet to the backseat but i lifted up the backseat and unhooked the whole thing
 
Reply




All times are GMT -4. The time now is 12:23 PM.