97 neon crank sensor wiring
Thread Starter
|
Amateur
Joined: Nov 2005
Posts: 49
Likes: 0
97 neon crank sensor wiring
Where do the wires go from the crank sensor?
I think i need to run new ones.
I have traced the bucking/dying to a bad pigtail for the sensor, but since I have replaced the pigtail, I have experienced hesitation from a start and backfiring through the intake. I think I may need to replace all of the wiring.
I have checked the timing, it is correct, and I have replaced the CPS as well with one from a junkyard, and the car just went haywire, so I put the original back in. I did these changes with the battery disconnected.
I think i need to run new ones.
I have traced the bucking/dying to a bad pigtail for the sensor, but since I have replaced the pigtail, I have experienced hesitation from a start and backfiring through the intake. I think I may need to replace all of the wiring.
I have checked the timing, it is correct, and I have replaced the CPS as well with one from a junkyard, and the car just went haywire, so I put the original back in. I did these changes with the battery disconnected.
Last edited by DodgeGuy12; Aug 27, 2013 at 12:08 PM.
