Where does the voltage clamp and the RRFPR go? Im just trying to figure out the basic things i need to run a turbo on my stock motor, nothin fancy yet. Thanks!

 

http://i28.photobucket.com/albums/c2.../fuelsetup.jpg

http://www.splitsec.com/
Click on products, then signal clamps, and then on VC1 Voltage Clamp.

 

THANKS

 

Let me know how it goes.

 

i am in the same predicment you are. my buddy told me that it only works with a dohc because i am looking for a new car and he was like buy a 1st gen neon but make sure its a dohc and he would sell me his stock turbo and manifold. i am new to the forums can you explain to me how to post messages like this and stuff? thanks

 

so its not a good thing to run the Mopar Performance PCM with turbo?

 

no it isnt a good idea, but you can do it.....just maight cause you some problems....

the turbo will work on a sohc, but you need an adapter....the turbo should hold a higher gain on a dohc anyways

to post just go to the top of the main page and click on the NEW POST button

if you need any help, i have alot of pics on here floating around

 

The Mopar Performance PCM aggressively advances timing, bad for the turbo, since it also advances timing.