well i finally got the wifes car back together, now there is a horrible leak. it ran real good and didnt leak anything for a while, but as soon as i put it in gear trans fluid started pouring out the hole that the CV joint goes in. after most of the fluid ran out, then it just had a constant drip. within about 10 minuites about 3 quarts drained out. now it sux because we cant trade it in tomorrow...unless i figure it out before hand

i guess it might be a seal in there

 

there is an axle seal. mine started leaking for no apparent reason. I bought an axle seal puller to get the old one out. don't nick up the aluminum or it'll be leaking again...

 

where can i get an axel seal and how much????

i was checking autozone on the i-net and it says they dont have any......

 

only place i have ever been able to get one is at the stealership. you might luck out and find them at a trans shop.

 

well nevermind....i feel like a dumb ***......the shaft just wasnt locked in all the way....[:-]

 

It looks like I have the same deal as you, but I was able to get the part from Advance Auto Parts for only a few bucks(I'm not sure if I got the right thing now). It's a metallic ring that is colored red(the one currently on the car is blue).The size of the seals appears the same though.I haven't taken the axle off yet.Is there another seal I may be missing? The trans fluid drips right below the seal.

 

i ended up finding out that since i was in a huury putting the car back together, i didnt lock the shafts into the trans al the way....i was getting real frustrated and must of just thought they went it............but the car has long since been gone and traded it

hope your problem gets fixed easily