i have 1 front one and one rear that are about dead.......and i havent heard anything about that other car i told you about yet.....so i just think im gonna get the kyb's

 

thas wat I was worried about, thas why I was wonderin if they have cylinder sleeves. cause I wanted to bore mine to .40 over too but I've noticed alot of ppl's pistons goin thru the wall

 

damn spud what did you do, hit the lottery? lol

theres a machine shop here in nc thats only gonna charge me $78 to clean my block out and bore it out .20 over[:'(]hahahahaahaha

 

no i just work....ALOT

i won my cams off of ebay last nite......crane #14 cams......
yesterday morning i ordered the pistons, rods, and rings too....so hopefully i will have them soon enough..
i think im gonna start ripping my motor out sunday so i can bring it to the shop..

i got my pricing on the block motor work:
remove and replace the pistons, freeze plugs, resurface the head, balance the crank, complete reassembly, bore/hone, pressure check block and head, hot tank it all, and a 3 angle valve job on the head.....$800.00
im hopeing to drop off the block mid-next week

 

damn...so your doing head work too....what u gonna do about axles?

 

Is it weird that I was little aroused while reading that [8D]

 

no not wierd at all.....i just cant wait to get it all done
i just got an email saying that my cams were shipped out today...so hopefully they will be here in a few days....

i will deffinately have to get this car dynoed when its done.....i wonder how much power its gonna have

im just gonna use the stock axels for a while........until they break.....then i will figure out what i am gonna get for new ones

 

good luck with all that hope it turns out well

 

oh im sure it will turn out great....just sux that im gonna still be using the car to drive for work....hopefully after its done im gonna get a different car to use for work and this one can just sit in the garage and collect dust

i cant wait to hear the motor idle with those cams in it