v6 neon??
#2
RE: v6 neon??
ORIGINAL: 96 srt4
can you take a 2.5 out of an aenger and put it in a neon??
can you take a 2.5 out of an aenger and put it in a neon??
#6
RE: v6 neon??
You need a few other things as well. Here is some info that rrwertz provided.
ORIGINAL: rrwertz
2.4 is the easiest motor swap there is, easier than any honda.
what is your car? year/engine, etc. what 2.4 are you putting in?
if your car is sohc, get a 97-99 dohc engine harness.
need a stratus 2.4 pass mm adapter plate.
pass side adapter.
trim fmm to clear oil pan.
24 lb injectors
move injectors down one
swap outer coil pack wires
sohc hood will not work, no matter how much you cut out
need a dohc computer.
use neon tranny.
get a modded srt clutch. pretty cheap. need new to bearing
dohc tps and iac neon
dohc cams turn cam magnet 90 degrees
new water pump, srt tensioner, upgraded tensioner bolt, oil pump, timing belt, headgasket are good things to replace while it is easy.
2.4 is the easiest motor swap there is, easier than any honda.
what is your car? year/engine, etc. what 2.4 are you putting in?
if your car is sohc, get a 97-99 dohc engine harness.
need a stratus 2.4 pass mm adapter plate.
pass side adapter.
trim fmm to clear oil pan.
24 lb injectors
move injectors down one
swap outer coil pack wires
sohc hood will not work, no matter how much you cut out
need a dohc computer.
use neon tranny.
get a modded srt clutch. pretty cheap. need new to bearing
dohc tps and iac neon
dohc cams turn cam magnet 90 degrees
new water pump, srt tensioner, upgraded tensioner bolt, oil pump, timing belt, headgasket are good things to replace while it is easy.