Code 37, 32, 17 1995 Ram 4x4
#1
Code 37, 32, 17 1995 Ram 4x4
I have a 95 1500 4x4 318. My check engine light is on. I am getting codes 37,32,17
It's shifts a little hard when going in to high gear. Seems like it don't have the power it should. I changed the trans filter and fluid.
Also have 2 sets of wires, at the back of the trans that are not connected. Don't know what they are.
Also, steering is a little loose, ball joints seem ok. Any thoughts?
Any help would be great.
It's shifts a little hard when going in to high gear. Seems like it don't have the power it should. I changed the trans filter and fluid.
Also have 2 sets of wires, at the back of the trans that are not connected. Don't know what they are.
Also, steering is a little loose, ball joints seem ok. Any thoughts?
Any help would be great.
#2
you might get more help if you posted in the right section
https://dodgeforum.com/forum/2nd-gen-ram-64/
from what i have read in the 2nd gen section the trans have quite a few flaws that tend to lead to failure. your truck most likely does not have the power it use to because of a blown plenum gasket which will let oil get into your intake so your engine will burn oil which can cause your cat to clog and o2 sensor to go bad.
https://dodgeforum.com/forum/2nd-gen-ram-64/
from what i have read in the 2nd gen section the trans have quite a few flaws that tend to lead to failure. your truck most likely does not have the power it use to because of a blown plenum gasket which will let oil get into your intake so your engine will burn oil which can cause your cat to clog and o2 sensor to go bad.