1st Gen Ram Tech '93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Horn/radio problems

Thread Tools
 
Search this Thread
 
Old Jul 18, 2013 | 09:46 PM
  #1  
85d250's Avatar
85d250
Thread Starter
|
Registered User
Joined: Jun 2013
Posts: 12
Likes: 0
Default Horn/radio problems

Horn and radio just stopped working. The fuses are good anyone have any ideas?
 
Reply
Old Jul 18, 2013 | 09:57 PM
  #2  
crazzywolfie's Avatar
crazzywolfie
Legend
15 Year Member
Liked
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Default

do all you lights still work?
 
Reply
Old Jul 18, 2013 | 10:02 PM
  #3  
85d250's Avatar
85d250
Thread Starter
|
Registered User
Joined: Jun 2013
Posts: 12
Likes: 0
Default

I pull the inside light fuse to use for my turning light. Does the inside light fuse run the horn and radio too?
 
Reply
Old Jul 18, 2013 | 10:07 PM
  #4  
crazzywolfie's Avatar
crazzywolfie
Legend
15 Year Member
Liked
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Default

no but i think they should be powered by the same fusible link. if your headlights and all the exterior/dash lights don't work then you might have a blown fusible link.
 
Reply
Old Jul 18, 2013 | 10:29 PM
  #5  
85d250's Avatar
85d250
Thread Starter
|
Registered User
Joined: Jun 2013
Posts: 12
Likes: 0
Default

Ok I know my headlights not working yet I have to replace the switch but the radio and horn worked before I pulled the fuse
 
Reply
Old Jul 18, 2013 | 10:34 PM
  #6  
crazzywolfie's Avatar
crazzywolfie
Legend
15 Year Member
Liked
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Default

what about all the other lights? you could try testing to see if there is power at the horn/radio fuse. if there no power then it is most likely a bad fusible link. they eventually go over time.
 
Reply
Old Jul 18, 2013 | 10:48 PM
  #7  
85d250's Avatar
85d250
Thread Starter
|
Registered User
Joined: Jun 2013
Posts: 12
Likes: 0
Default

It was the fuse I pulled out so it works now
 
Reply




All times are GMT -4. The time now is 02:50 AM.