2nd Gen Dakota Tech 1997 - 2004 Dodge Dakota Tech - The ultimate forum for technical help on the 2nd Gen Dakota.

2001 3.9 V6 Dakota Won't start!

Thread Tools
 
Search this Thread
 
  #1  
Old 09-10-2007, 03:58 PM
kegger408's Avatar
kegger408
kegger408 is offline
Thread Starter
Join Date: Sep 2007
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default 2001 3.9 V6 Dakota Won't start!

My 2001 Dakota with a 3.9 V6 , 5 speed manual transmission won't start. Won't even turn over! I thought it might be the clutch since that was ready to be changed, but after changing it, the truck still won't start.
I have plenty of power, and have had the starter checked out. What else can it be? I only have 82k mi and maintain regularly. I appreciate any advice.
 
  #2  
Old 09-10-2007, 04:45 PM
f0x672's Avatar
f0x672
f0x672 is offline
Champion
Join Date: Aug 2006
Location: poconos, pa
Posts: 2,530
Likes: 0
Received 1 Like on 1 Post
Default RE: 2001 3.9 V6 Dakota Won't start!

hows your battery?... do you press in your clutch pedal when you try to start it?.... maybe your clutch safety switch is shot, if there is one, should be
 
  #3  
Old 09-10-2007, 05:44 PM
kegger408's Avatar
kegger408
kegger408 is offline
Thread Starter
Join Date: Sep 2007
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2001 3.9 V6 Dakota Won't start!

Checked the Battery and that is fine, and I do have the clutch pedal pressed down when I attempt to start. How do I know if the Clutch Safety Switch requires replacement? And, if that is not the problem, what else can I look at?
 
  #4  
Old 09-10-2007, 06:52 PM
steve05ram360's Avatar
steve05ram360
steve05ram360 is offline
Hall Of Fame
Join Date: Jan 2004
Posts: 12,827
Received 235 Likes on 218 Posts
Default RE: 2001 3.9 V6 Dakota Won't start!

is the motor cranking? if not, then ignition switch, clutch safety switch are a couple of places to look. if it is then crank sensor, fuel pressure & coil would be your next starting points...
 
  #5  
Old 09-11-2007, 10:22 AM
4x4kota's Avatar
4x4kota
4x4kota is offline
Veteran
Join Date: Dec 2006
Location: Jordan, Ontario
Posts: 283
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2001 3.9 V6 Dakota Won't start!

if the clutch switch is bad or even if the solinoid is bad i think you can still jump across the solinoid prongs and the truck should start or at least crank. Correct me if i'm wrong, but i remember doing this to an old ranger that i had when the solinoid went.
 
  #6  
Old 09-11-2007, 04:27 PM
plw1975's Avatar
plw1975
plw1975 is offline
Join Date: Sep 2007
Location:
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2001 3.9 V6 Dakota Won't start!

Does it turn over when you start it? Or does it ack like it just isn't firing? Mine wouldn't start a few months ago. I took the belt off and started it to make sure it wasn't a pully and sure enough it started. Turns out it was my tention pully. When I grabbed it and tried to turn it it was very hard to turn. You might also want to check you AC compressor pully and make sure it isn't what is causing the problem if you tention pully isnt the problem.
 
  #7  
Old 09-18-2007, 08:14 AM
barstickbilly's Avatar
barstickbilly
barstickbilly is offline
Join Date: Feb 2007
Location:
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2001 3.9 V6 Dakota Won't start!

I had that same thing happen when I disconnected the battery, Found out It had an alarm system that I had to reset, works fine now.
 



Quick Reply: 2001 3.9 V6 Dakota Won't start!



All times are GMT -4. The time now is 06:04 AM.