Anyone else have this issue? I drove the truck 450 miles this weekend and the shift **** turned about 120*. I can't physically turn/spin the ****. I think it's the actually shifter that's turning.

Am I the only one?!

 

Is it a manual? If so it just sounds like the **** is loose theres a nut under the gear pattern diagram. Pry that off with a screw driver and tighten it down should be good to go.

 

Well the shift **** is NOT loose AT ALL, which is why I'm actually confused over this.

 

The gear pattern insert that's in the **** likely spun, not the **** or shifter.

 

Well that makes perfect sense! I'll check it out tomorrow!

 

Haha, yeah I had the same thing with mine when I first got it. I thought the **** was turning and I couldn't turn it back and was confused why my gear pattern was know 90 degrees the wrong way... found out that the gear pattern is just a cap over the top of the screw that holds the **** in place and it turns on its own. Especially if you use your entire palm over the **** it will turn quite easy.

So don't worry, your transmission isn't going to fall on the ground or anything tomorrow or pull the shifter out grabbing 3rd lol.

btw on a side note, how much power are your cars making? They look good.