question regarding front end checks; upper ball joint
#32
it's a 2wd theres nothing to indicate 4x4 but it does have two vertical bilts in the UCA I found the correct part it does have holes for brake line. as for level ground its not its on a slight slope with driver side on the down. didn't think about that (retard) Im about to purchase the parts from rock auto any recommendations before I do so. I saw alot about moog parts but they are way more expensive I was looking at dorman. Also update it looks as if my outer tie rods have been replaced already on both sides.... so should I just do both inners or go ahead and do outers as well ( the outer tie rods look to be moog already they can have port to grease them.
i moved my truck so it would reverse the side of the truck that was on the slope and its is still the same in reguards to the upper ball jopint and rim spacing.
i moved my truck so it would reverse the side of the truck that was on the slope and its is still the same in reguards to the upper ball jopint and rim spacing.
Last edited by sdorsey.shh11206; 04-18-2013 at 05:37 PM.
#35