Polyurethane trans mount?
All Star
Joined: Mar 2013
Posts: 783
Likes: 0
From: Eastside Tucson AZ
The ones I have are http://www.energysuspensionparts.com...eplaces1370910
Bolt range on the top (that's the widest part of the mount) is 3.272" to 4.747" . Bolt range on the bottom is one single bolt center mount, OR center of the outside on one side to center of the other side 1.5" for two bolt mount.
windows print screen
Bolt range on the top (that's the widest part of the mount) is 3.272" to 4.747" . Bolt range on the bottom is one single bolt center mount, OR center of the outside on one side to center of the other side 1.5" for two bolt mount.
windows print screen
Thread Starter
|
Section Moderator
Joined: May 2012
Posts: 1,564
Likes: 9
From: Concord, CA
Looks like it will bolt to the transmission (my bolts are 4.75" on center) but I'll have to drill some holes in the crossmember (which isn't quite as easy as it sounds because of the crossmember design, IIRC) because my bottom bolts are 2.25" on center.
I think I might give a shot. It's not technically a transmission mount, but I think it might work.
I think I might give a shot. It's not technically a transmission mount, but I think it might work.
All Star
Joined: Mar 2013
Posts: 783
Likes: 0
From: Eastside Tucson AZ
Looks okay. I'm gonna do with what I have on hand. I'll drill the xmember if I need to. (I have a nice little 90 degree air drill just made such things.) No hurry for me, I'm knee deep in working on an old BMW motorcycle at the moment.