front junction block fitting size/type
Thread Starter
|
Legend
Joined: Feb 2005
Posts: 8,058
Likes: 184
From: Fort Worth, TX
front junction block fitting size/type
ok, so thanks to an hour of searching, I know our trucks use 3/16" tube. I also know that one master cylinder port is 1/2" and the other is 9/16".
Now, I have found conflicting reports that the front junction block is 3/8" or 7/16", and whether the flare is inverted or bubble. I even found a post saying it's 10 x 1.0 metric thread (but that wouldn't make sense on a 3/16 line?)
So can somebody for sure tell me what the heck goes into the junction block? Specifically, I'm looking at the line that goes from the M/C to the junction block, so that I can put a line-lock on it. I really dont want to go digging in the junkyard and rip out a junction block and brake line to take to NAPA....
Now, I have found conflicting reports that the front junction block is 3/8" or 7/16", and whether the flare is inverted or bubble. I even found a post saying it's 10 x 1.0 metric thread (but that wouldn't make sense on a 3/16 line?)
So can somebody for sure tell me what the heck goes into the junction block? Specifically, I'm looking at the line that goes from the M/C to the junction block, so that I can put a line-lock on it. I really dont want to go digging in the junkyard and rip out a junction block and brake line to take to NAPA....