Hi Guys
I need to replace my rear axle seal on my 2004 durango slt
i order the seal an the bearing just in case i need to replace it.
i know for sure i have to open the rear differential housing and remove the locking pin and the "C" clip holding the axle.
My question is the bearing press on the axle or i stay inside the axle tube?
and the seal is mounted on the end of the tube?

or i need to remove the old bearing and collar to access the seal
i have no diagram of the axle construction

Thanks

 

I'm almost certain the 9-1/4 rear end is just your standard setup with bearing pressed in the tube and then seal pressed in the end.

 

Yes, The 9.25 has stayed the same for the most part since the 70's.

http://autopartmaster.com/en/?action...4&id_pic=29488

 

Thanks Guys for the replied
I was sure you would come up for helping me out
thanks a million