When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
does anyone kno how to do cutouts on a 2000 bumber
Very carefully.
The only way I would know on a 2000 would be to make a template of the exhaust tips, then increase that by a little and then apply the cutout to the bumper, then cut them out with a Dremel and the proper bits.
Adionik, you should check the inside of your rear bumper because there might be a guide already molded into the plastic for the cutouts...not positive on that though.
isnt our mid section 2.25? some guy on 2gen is selling this muffler hope i could get it. he has to ship it though and thats where i get screwed hopefully not to much. when your cutting the cutouts i would say measure twice cut once. and offcoarse do it very carefully. findsomeone that has a steady hand.