The Official 2nd Gen RAM Forum OT thread
Champion
Joined: Jun 2012
Posts: 3,096
Likes: 2
From: Iowa
That's for sure!
Champion
Joined: Jun 2012
Posts: 3,096
Likes: 2
From: Iowa
How's that?
Started the John Deere 2640 NA 4cyl diesel. Took me over 1/2 hour to start. I'm certain the injector pump is going out on it. One cylinder was missing when I gave it starting fluid and when idling it is missing ever so slightly on one cylinder. Darned.
Started the John Deere 2640 NA 4cyl diesel. Took me over 1/2 hour to start. I'm certain the injector pump is going out on it. One cylinder was missing when I gave it starting fluid and when idling it is missing ever so slightly on one cylinder. Darned.
Legend
Joined: Mar 2011
Posts: 8,914
Likes: 4
From: Fredericksburg, Virginia
Wife came home all worried, said the truck had gotten hot, said the needle went a little past the middle line, obviously the dash gauge isn't the most accurate but even the half mark is warmer than normal for my truck.
Also said it felt like the truck was jerking. (keep it clean boys)
Took it for a ride, didn't get warm, even to the half mark, even with the heat off. Did record some video of my shifting issue. I'll probably post it up so I can get some ideas.
Also said it felt like the truck was jerking. (keep it clean boys)
Took it for a ride, didn't get warm, even to the half mark, even with the heat off. Did record some video of my shifting issue. I'll probably post it up so I can get some ideas.
Champion
Joined: Apr 2011
Posts: 3,574
Likes: 0
From: Harrisburg,PA
Champion
Joined: Jun 2012
Posts: 3,096
Likes: 2
From: Iowa
Wife came home all worried, said the truck had gotten hot, said the needle went a little past the middle line, obviously the dash gauge isn't the most accurate but even the half mark is warmer than normal for my truck.
Also said it felt like the truck was jerking. (keep it clean boys)
Took it for a ride, didn't get warm, even to the half mark, even with the heat off. Did record some video of my shifting issue. I'll probably post it up so I can get some ideas.
Also said it felt like the truck was jerking. (keep it clean boys)
Took it for a ride, didn't get warm, even to the half mark, even with the heat off. Did record some video of my shifting issue. I'll probably post it up so I can get some ideas.
Champion
Joined: May 2012
Posts: 3,065
Likes: 1
From: Renton, WA
getting good fuel pressure to the injection pump?
injector could also be suffering from too low of a pop pressure and might need a rebuild..
