Anyone got any tips on getting the ignition cylinder out if the column?

 

i don't think there is any tips or tricks. i think you have to take the steering wheel off and remove the turn signal switch. by that point you should be at switch.

 

Well i got the wheel off but im not entirely sure on how to remove the turn signal lever or switches for that matter.. There isnt anything online that I have been able to find that shows this in any kind of detail

 

i think there is one screw that goes through the turn signal cam and into the threads in the turn signal lever. i think there might also be a round clip around the center that has to be remover to get at the ignition switch after all the screws have been removed.

 

Haynes manual...

 

Well I dont have the extra 30 bucks for a Haynes right now. Im in the process of looking for a wiring diagram for the ignition right now so I can just run a push button start that will be tucked up under the dash... Ive got it most of the way apart now and the push button was mentioned and I thought "Hey thats a good idea!" lol so I will probably end up just putting it all back together and going that route.. Ive always wanted a push button anyway

 

you are extremely lucky. i just happen to find the diagram you are looking for and i have been trying to find to help others in the past.

 

THANK YOU!!! I was looking for a diagram and everyone just kept trying to explain it hahaha.. I work much better with a picture.... I will be saving that for a future reference


Looking at that diagram Im a little confused... Should I run a 2 switch setup one for power and accesory and another to actually start it? If so which way should I run the wires to the switches?

 

ya. some diagrams are almost impossible to locate for these trucks. i was trying to locate one for cruise control and it took forever but i found one. if you are looking for any others just ask and i will see what i can find. i slowly upload what i have as people ask.

 

Well I did manage to get the ignition cylinder replaces.. There was a tiny little snap ring that I couldnt see due to the amount of grease on it so that is all taken care of now... Onto the next problem.. I was in the process of dropping the fuel tank and the bolts snapped.. I cant find them anywere nor can I find new straps... Not sure what route im gonna go with this... Ohh well.. I wasnt expecting it to be perfect.. Now to continue my search for new parts