When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I know this sounds crazy but I have read about guys using rattle can paint and then water sanding it and it looks like a pro did it.
I also know a guy who used a roller and a couple gallons of paint and rolled it on and it turned out decent.
It is called redneck engineering aka A poor man's paint job
I tried it on a scrap hood I have for setting spray gun....not too bad, but too much sanding to blend.
Originally Posted by Goatley
I cant get my latch to align right with the striker I need help here I just unbolted it and bolted up the new door.
Does the striker seem to high or too low? Can you see it as you close door against it slowly? If you can see which way it may need to move, loosen it, move slightly, and barely tightned screws and see if it works. Trial and error.
it hits good but the latch itself is on the outside of the striker and not making contact to the striker to actually latch itself to where it wont come open.
