Hello, I am from the Czech Republic and I would like to apologize for my English. But I have such a problem and I do not know where to go for advice. I would need a paper from the seller, where the dimensions of the car (width, height, length) with us, it is necessary to have these dimensions written in the documents from the vehicle. Since somebody entered wrong dimensions on import, there are problems with it and I cannot fix it without proof from seller / manufacturer. Unfortunately, nobody will do this to us. Can any of you advise me where they would do this to me? Thank you This is a Ram 1500,5.2, 4x4 year of manufacture 2000

 

if there are no dodge dealers in CR try contacting a fiat dealer or fiat CR. Fiat owns dodge. Maybe they can get factory information for you.

 

Fiat in CZ has already tried and either they do not have or are not willing to advise. Means like this deal with writing rubber and also had to contact the US dealer. But thank you for your answer

 

Maybe even a manual or a sheet where the overall dimensions of the car were written would be enough, then I would just have it officially translated into the Czech language. But unfortunately I never found anything like that.

 

https://redirect.viglink.com/?format...&txt=2000-2001

 

That's the link for the factory service manual. The manual for my 95 has dimensions on page 5 in the introduction.

 

I have a service manual, but there are no overall dimensions of the car. I do not know how you look the user manuals for the car, but there should be a picture of the car and it wrote all the dimensions (length, width, height)

 

 

thank you very much. can this be found somewhere in PDF version?

 

Should be close to the front. (top??)