After I got my BJ's done, I went to get an alignment, but found out the bottoms had come out so I had to repress them. Upon inspection, there was a slight leak coming from the water pump. My UTI buddy says use a little ATV and I believe that would work, considering it is a small leak and would just be a temp. fix, because I want to do the 180* Tstat and may as well stick a new water pump in while I'm at it. Any DIY writeups? Couldn't find any through the searches. Info is always appreciated.

 

here you go... https://dodgeforum.com/m_224411/tm.htm

there is a DIY thread tacked to the top of the forum with alot of DIY links in it.

 

Awesome. Still thinking I'll go with some Sealant and see what that does. But great to know, I'll save over 200 bucks doing that. Throw in that thermostat and it's killin two birds with one stone.

 

if you do the t-stat, get a 180 and get a mopar gasket. it has sealant built into it so you dont have to add any. been using them for a long time and have never had one leak on me

 

Where's a good place to get Mopar parts?