hello i'm new here, read alot of the forums here and it sounds like this is the right place for information. I have a 99 2500 with a v 10, it is now sitting on an engine stand. Lost oil pressure,i'm just got it on a stand and haven't got to far into it yet. Just wondering if anyone has any sugestions of anything i should look closely at while i put it back together. The v 10 is new to me, the last truck i had was the 1500 with 360, so don't know much about the v 10, so any areas of concern if any would be helpful. The heads where just done last spring so they are fresh. The timing chain is going to get replaced. Will probaly know how bad it is in a couple of days when i get it down a little farther. Thank you in advance for any tips Brian