I am going to replace my sway bar bushings and end links on my Ram. The end link bushings are severly cracked up. So I measured the sway bar using a cresent wrench. (then measured the gap in the wrench), and I came up with about an inch and a quarter. I think I have a 32 mm bar as it is stock. 2000 4X4 1500. I was hoping to tap into All Ya' ALLs knowledge before I order the new stuff. Thanks for you help guys.

 

Buy a micrometer this will allow you to get a better measurement. Or just ditch the swaybar, you dont need one anyhow.

 

without buying a mic. anyone know what size it should be ?

 

When I did mine, it was 32mm. Service manual says that there was two different ones though, a 30mm and a 32mm. Seems the most common is the 32mm though.

 

Thanks alot Silver_Dodge. I was leaning towards the 32mm bar. Its just that I wanted another opinion before I ordered. Thanks again.