2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

***3 inch lift question***

Thread Tools
 
Search this Thread
 
Old Jan 23, 2005 | 02:25 PM
  #1  
kazorb's Avatar
kazorb
Thread Starter
Joined: Sep 2004
Posts: 11
Likes: 0
Default ***3 inch lift question***

hello, i just bought front 3 inch coil spacers, rear add-a-leaf kit, and 4 longer shocks. all rough country. the full kit from rough country includes upper/lower control arms, sway bar drop brackets, and a track bar drop bracket. my question is, are these parts an absolute must???
thanks

2000 ram sport 4x4
 
Reply
Old Jan 24, 2005 | 02:14 AM
  #2  
DWILHA's Avatar
DWILHA
Joined: Jan 2005
Posts: 35
Likes: 0
From: DALLAS, TX
Default RE: ***3 inch lift question***

YES THEY ARE, IF YOU RAISE THE FRONT WITH SPRINGS IT WILL SEND THE TIRES INWARD, KINDA LIKE USING A JACK IN THE CENTER OF THE TRUCK, IF YOU JACK IT UP THE WHEELS DROP AND SLIGHTLY GO INWARD, LONGER SWING ARMS LET THE WHEELS STAY STRAIGHT AS YOU RAISE IT WITH THE SPRINGS, IF YOUR GOING JUST FOR A RAISED LOOK, GET THE 3 INCH BODY SPACERS AND THE BUMPER KITS, ITS AROUND 1300 DOLLARS INSTALLED AND LOOKS GREAT.
 
Reply
Old Jan 24, 2005 | 03:58 AM
  #3  
hometheaterman's Avatar
hometheaterman
Champion
Joined: Jan 2005
Posts: 4,268
Likes: 1
From:
Default RE: ***3 inch lift question***

He already bought it so unless he can return it I would stick with that not go with a Body lift plus the Body Lifts look cheap and don't do much other than allow for bigger tires. They look ok if you use a small one in combination with a suspension lift. I would stick with the suspension lift and install all the parts.
 
Reply
Old Jan 24, 2005 | 09:20 AM
  #4  
moparmania's Avatar
moparmania
Veteran
Joined: Jul 2004
Posts: 296
Likes: 0
From:
Default RE: ***3 inch lift question***

those parts are important, but if you have a solid axle front end the new springs should not cause major toe in like it would if you lifted a independant fromnt end . steer away from the body lift if you can. these trucks have alot of weight to them so if you do end up with a body lift look into making stronger mounting plates for the body mounts. just my 02
 
Reply
Old Jan 25, 2005 | 05:23 PM
  #5  
kazorb's Avatar
kazorb
Thread Starter
Joined: Sep 2004
Posts: 11
Likes: 0
Default RE: ***3 inch lift question***

thanks everyone,
i called rough country and they said i do need all the parts. i ordered everything i needed straight from them. they were very helpful. i found out the hard way it is less expensive to buy a full kit, rather than trying to piece it together. in my case i spent about $70.00 too much.
 
Reply




All times are GMT -4. The time now is 02:03 PM.