2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

loud clunk

Thread Tools
 
Search this Thread
 
  #1  
Old 11-17-2008, 03:59 PM
OlRed's Avatar
OlRed
OlRed is offline
Registered User
Thread Starter
Join Date: Jul 2008
Location:
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
Default loud clunk

There is a loud clunk almost everytime I slow down to stop or start up from a stop. It also happens when cornering. It is a loud sound and I can feel it underneath my feet sometimes. Could this be a u-joint? if so, how would you look one over? Also what else could it be? steering?
 
  #2  
Old 11-17-2008, 04:03 PM
PurplDodge's Avatar
PurplDodge
PurplDodge is offline
Legend
Join Date: Jan 2008
Location: Indiana
Posts: 8,321
Likes: 0
Received 12 Likes on 10 Posts
Default

Mine used to do this. Replaced the shocks. Fixed any clunking(in my truck).
 
  #3  
Old 11-17-2008, 04:36 PM
zman17's Avatar
zman17
zman17 is offline
Retired Moderator - RIP
Join Date: May 2008
Location: NH
Posts: 18,729
Likes: 0
Received 17 Likes on 16 Posts
Default

Yes check the u-joints on the drive shafts. And the rear end gears might be shot.
 

Last edited by zman17; 11-17-2008 at 04:41 PM.
  #4  
Old 11-17-2008, 07:47 PM
Laramie1997's Avatar
Laramie1997
Laramie1997 is offline
Grand Champion
Join Date: Sep 2008
Location: Springfield MO
Posts: 6,980
Likes: 0
Received 4 Likes on 4 Posts
Default

mine was doing the same thing... I turned out that it was the front driveshaft boucing around because the four bolts holding on had walked loose
Has anyone had problems with this? i tightend the bolts a couple of months ago. Went to use the 4x4 last week and everything engaged, but when i went to pull forward there was a loud clunk and the 4x4 shifter went loose. Turns out that the bolts had walked almost completly out and they were catching on the 4x4 shifter tearing off the gromet holding the shifter together.
 
  #5  
Old 11-17-2008, 09:47 PM
98DodgeRam1500's Avatar
98DodgeRam1500
98DodgeRam1500 is offline
All Star
Join Date: Jan 2008
Posts: 935
Likes: 0
Received 1 Like on 1 Post
Default

I get a clunking also, I notice it at low speeds, and it sounds/feels like its coming from the passenger side. I had that u-joint replaced, but noticed it went bad already. Its going back in this saturday to get replaced. I will let you know if the clunking goes away.
BUT I have noticed that the instant I touch, and i mean touch the brakes it goes away.
So I might have bad caliper guides. I have taken the wheel and did a visual, but it didn't seem any different than the other side.

if you find out what yours is, let us know.

I did check the shock, and the sway bar links.
 
  #6  
Old 11-17-2008, 10:03 PM
OlRed's Avatar
OlRed
OlRed is offline
Registered User
Thread Starter
Join Date: Jul 2008
Location:
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
Default

the front and rear driveshafts are good and solid. Its not the brakes. What else should i check? How do you check u-joints?
 
  #7  
Old 11-17-2008, 10:05 PM
OlRed's Avatar
OlRed
OlRed is offline
Registered User
Thread Starter
Join Date: Jul 2008
Location:
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
Default

Oh and i will have to see about the shocks, and ill check the swaybar when i have time. thanks, ill keep this updated
 
  #8  
Old 11-17-2008, 10:18 PM
dhvaughan's Avatar
dhvaughan
dhvaughan is offline
Hall Of Fame
Join Date: Jul 2006
Location: Gainesville, Ga.
Posts: 12,204
Likes: 0
Received 8 Likes on 8 Posts
Default

clunk sound under drivers or passenger feet is likely to be the lower front shock bolt. that sucker needs to be torqued to 100 pounds.
 
  #9  
Old 11-17-2008, 11:14 PM
98DodgeRam1500's Avatar
98DodgeRam1500
98DodgeRam1500 is offline
All Star
Join Date: Jan 2008
Posts: 935
Likes: 0
Received 1 Like on 1 Post
Default

wish my clunk was the shocks, i would have found that quickly since that was my second thought. I have a feeling its my caliper guides, can you get those seperately?
 
  #10  
Old 11-28-2008, 05:45 PM
98DodgeRam1500's Avatar
98DodgeRam1500
98DodgeRam1500 is offline
All Star
Join Date: Jan 2008
Posts: 935
Likes: 0
Received 1 Like on 1 Post
Default

Dropped the truck off this morning, and got it back a little while ago.

I haven't noticed the clunking, so it might have been the bad u-joint... or maybe when they reassembled that side, it might have gone back togther better????????

Anyhow, I will have to keep an eye out for excessive wear as a sign of something else going.
 


Quick Reply: loud clunk



All times are GMT -4. The time now is 09:08 AM.