2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Speedometer gone out

Thread Tools
 
Search this Thread
 
Old Jan 19, 2009 | 09:53 PM
  #1  
doorikuhn's Avatar
doorikuhn
Thread Starter
|
Registered User
Joined: Jan 2009
Posts: 1
Likes: 0
Default Speedometer gone out

The speedometer on my ram does not work the needle stays at zero and doesn't move. What could be the problem?
 
Reply
Old Jan 19, 2009 | 10:24 PM
  #2  
dhvaughan's Avatar
dhvaughan
Hall Of Fame
Joined: Jul 2006
Posts: 12,204
Likes: 10
From: Gainesville, Ga.
Default

AAAARRRRGGGGGHHHHHHHH. what year ?

early models had a gear in the transmission. later years have 2 speed sensors. the one in the tailshaft of the trans/t-case is called the speed sensor. the one on the top of the rear pumpkin is the rear wheel abs sensor. both figure in. check elec connector on each for mud or damage. sometimes these set of brake and abs lights on dash.
 
Reply
Old Jan 19, 2009 | 11:24 PM
  #3  
BigDodge99's Avatar
BigDodge99
Rookie
Joined: Dec 2006
Posts: 89
Likes: 0
From: Indiana
Default

Same problem on my 99. Havent figured it out yet.
 
Reply
Old Jan 19, 2009 | 11:30 PM
  #4  
modracer's Avatar
modracer
Registered User
Joined: Nov 2007
Posts: 49
Likes: 0
From: grand valley, on
Default

bigdodge99

douse yours work after a certan speed cause on my 99 it didnt work from 0km/h-60km/h and its the transmition sencer gone so i put a new one in and its all good
 
Reply
Old Jan 19, 2009 | 11:49 PM
  #5  
BigDodge99's Avatar
BigDodge99
Rookie
Joined: Dec 2006
Posts: 89
Likes: 0
From: Indiana
Default

No, it doesnt work at all as well as my odometer. I have a code for speed sensor a and even though I dont know which one that is I replaced them both and it still doesnt work. I believe the piece that plugs into the axle sensor is damaged but I am having a hard time finding a replacement.
 
Reply
Old Jan 20, 2009 | 12:12 AM
  #6  
modracer's Avatar
modracer
Registered User
Joined: Nov 2007
Posts: 49
Likes: 0
From: grand valley, on
Default

would the one out of a 1500 ram van work for ya cause i just got one for scrap and im pulling the motor cause its rebuilt and my dodge needs a new one lol so i have the rest of the parts laying around
 
Reply
Old Jan 20, 2009 | 12:15 AM
  #7  
BigDodge99's Avatar
BigDodge99
Rookie
Joined: Dec 2006
Posts: 89
Likes: 0
From: Indiana
Default

It might. Could you take a pic of it so I can see the plug. I think it will unless there is a dana 60 under there. thank you
 
Reply
Old Jan 20, 2009 | 12:37 AM
  #8  
modracer's Avatar
modracer
Registered User
Joined: Nov 2007
Posts: 49
Likes: 0
From: grand valley, on
Default

yup next time im out at it i will
 
Reply
Old Jan 25, 2009 | 08:50 PM
  #9  
Slugger's Avatar
Slugger
Registered User
Joined: Jan 2009
Posts: 1
Likes: 0
From: New Baltimore, Mi
Default

My 99 doesnt read until 40-45 mph and both the brake and the abs lights are lit
 
Reply




All times are GMT -4. The time now is 08:17 AM.