how big of a job is it gonna be to replace the lower control arm on the passenger side of my 97 2wd ram ???
its bent and makes my truck sit a whole inch lower on that side so im going this week to a savage yard and pick one up .Ill do ball joints while im at it

 

it shouldn't be real bad just be careful with the spring. besides doing the bjs it just three move things to take off shock them c-arm bolts....use a jack to support the c-arm when taking out the shock with slowly let it down the spring still has presure on it.

heres a diy i did on the bjs https://dodgeforum.com/forum/2nd-gen...placement.html

good luck with the project...hope i help sum

 

Control arm is pretty easy, Ball joints will take a little more time but not hard IIRC (only done one 2wd). Good to do it all at once I suppose.