Doing something extreme with the truck and need the middle seat gone. I'm keeping the driver (of course) and the passenger but the middle fold down seat has gotta go.

I can see a bolt holding it in the back which would be easy to remove but in the front it looks like the seats are held together by something circle that has no grip on them... I thought maybe prying them undone? Not sure if theres a easy way to get it separated or not. Ya'll done this before and know how? Any suggestions would be appreciated.

If you help lol I will upload pics of what I did when I'm done )

 

4 bolts 13mm... the mounting bracket will need to be cut out

 

unbolt from up under the middle seat, then you can get that out of the way and take care of your brackets

 

i took some pics, this is the bracket for the front on the passehger side, its got rivets


heres a pic of the back bracket, its welded to the seat bracket and if youre wantin to make it look good youll have to pull the seat to cut it off right..........






you can see in both pics that the brackets go up under the middle seat and bolt upwards........i wouldnt suggest taking all the seats out as one unless youve got help, i tried this morning

 

any hints as to what your doin? custom fiberglass console?, sub box? mini fridge? stripper pole?............just some ideas incase you havent fully decided

 

looks like a cut off wheel and your done .
thanks Gav1n8 now I have another project for my ram. Im thinking (scary hu)
a custom center console for my controler for my plow and light switches. sub box maybe. elemate the seat so the kids wont fight who sits in the middle.

 

Personally, found it much easier to take the seats out one at a time. Removed most of the hardware off a set of 98manual pedestalls. Used 1/4 & 3/8" bits to drill out the rivets.
Thought they turned out pretty clean, more details on this page.
http://www.rm-indy.com/seat_install.htm

 

Lol Im putting in a 15 inch sub. Memphis mojo to be exact with a super bass probox. I got a 2400 watt hifonics amp and a 3 farad cap making it jiggle. The dimensions are exact.

So lemme get this straight? It's all bolts right? I don't need to cut anyting? I'm hoping to complete it tomorrow morning. Will take pics then

 

damn very nice. Like what they did by painting it.

 

Used an angle grinder to remove the back supports