When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
So there i was, first time pulling the truck after all the work. I pull this truck TUG-A-TRUCK style. The front Driveshaft that we had to clearence at the CV joint did not fair so well..haha..It shatterd and a peice hit the case of the overdirve on the tranny..Small crack in that as well..But anywho back to the driveshaft..what company do you guys like to get a custom High Angle driveshaft..The truck is now 7.5in high so im going to need something speacial..Thanks.
IM from ohio and cant find a local shop that has a high angle CV joint. Thats what i need but the guys over the internet want 800-1100 bucks. If thats what i have to pay then so be it but i didnt know if there was a cheaper company.
OK thanks..maybe ill give them a call see what they say..I know the only person i have found so far that can do go work is Jesse at HighAngleDriveline.com. Its about 800 bucks for a joint and shaft but it might just be worth it.