I have a 98, 1500, 4x4, 5.9 gas. I recently replaced the timing chain and when I pulled the cover I ripped the oil pan gasket. I need to replace the entire gasket as it is too shot to RTV. Haynes says I have to raise the motor to get the oil pan down??? Do I need a hoist or can I jack the motor up from below? Also if I need a hoist can someone please tell me exactly where I should attatch the hoist to the block front and back. There are no empty holes I can see and I would prefer not to remove all of the accesory bracket if I don't have to. Thank you in advance for you assistance.

Evan

 

Evan

First you need to remove the fan shroud, loose the motor mounts, disengage the auto shifter and possibly remove the y-pipe from the exhaust. Then use a wood block on your jack and you can jack the motor at the balancer.

Hope this helps

Joe

 

when I replaced my oil pan I just took the starter off and the pan came right off

 

I agree, I've had the pan off four times with the motor in the truck..... it's a long story.

Granted, it's tight but the pan will come off without lifting the motor.