ceramic sensor problems
Thread Starter
|
Amateur
Joined: Dec 2009
Posts: 44
Likes: 0
From: Texas
ceramic sensor problems
I HAVE A 01 DODGE RAM 1500 and the sensor im talkin about is the one that controls the a/c heater blower motor on settins 1,2 and 3 but not 4 and it only work on 4 but i have already replaced it more than once and it seems really weak is there any way o by pass it
Professional
Joined: Jul 2009
Posts: 128
Likes: 0
From: New Jersey
I had the same problem.Did the soldier on the relay break off?..I replaced it 3 times then I had to re-soldier it..
It turned out that my blower motor was bad and once I replaced it all was fine..
https://dodgeforum.com/forum/2nd-gen...-resistor.html
It turned out that my blower motor was bad and once I replaced it all was fine..
https://dodgeforum.com/forum/2nd-gen...-resistor.html
Last edited by Eddielx; Dec 6, 2009 at 08:11 PM.
