Hey I was just saying the alignment looked off in that first pic. This truck is centered in the pic, and the tire on the passenger side looks straight, while the one on the drivers side is clearly turned outward.

 

I was in a truck with a Friend and hit a deer at 30MPH and all it did was dent the bumper a little.

But then my mom hit a deer at 25 in her jeep and did $6000 worth of damage

 

nice set-up... my deer cost me about $3,000... I hate deer

 

im pretty sure a deer here in NC, wouldnt be about his head would it that bar... but like i said, im changin it... it will be in a differant spot... but same concept... looks bad *** when its comin down the trail at ya....

i love the hieght of my truck.. my low beams, kill cars rear view mirrors...

and the alignment loos off,,, both wheels are slightly turns, but its alos the lighting... so you cant really see the other wheel turnd...

 

If you ever hit anything with that, those tubes are going to go straight through your radiator. It's nice to see someone else on this forum who actually builds stuff, and isn't just an e-faber.

 

no.. most the things on my truck, i built, i didnt buy a kit, and install on my truck to lift it either.. the magority of that lift was built by custom spring shops, and then bough parts and put all together... but thank you... i have seen some ohter people on here buiding too.. more extensive then this.. but still,,, its a start... and yes, the next design is going to the frame... not there... it was jsut the easiest way i could moke it up

 

Cool man. Be sure to finish writing this up. I would love to see how it turns out. Also, use tabs on the tubes, do not bolt straight through.

 

That is freakin sweet!!! Put those wires in some wrap so you cant see them.

 

yeah it is nice to watch the work you guys are able to do. Wish I could but just not able too I fab what I am capable of doing and bolt on the rest. Good job.