not detailed just some pics I took with the camera phone of my buddy and my kid working on the swap!


http://s916.photobucket.com/albums/a...%20Transplant/

 

good pics. did the engine hoist go up high enough to clear the radiator in that leaned down position?

 

very cool !

 

It barely cleared but I made it after I had to roll the truck back because I had the engine compartment under my garage door motor and the hoist hit it, let me tell you it is difficult to roll the truck and hoist with an engine on it at the same time

 

I'm sure someone will find these help full.

 

Was it a straight drop in like tranny and mounts,ect wise?if not what did you need to do?

 

Good pics, always enjoy putting a mtr back in

Buddies n I never remove our hoods to pull/install a mtr. We remove the intake mani, grab as low in the lifter valley as possible. It can go in over the fender or rad support without hitting the hood or grill