Installed a few more things, Street Scene Cal Vu Mirrors, TruxSport Tonneau Cover, Tranny Temp gauge, ScanGauge2, New Distributor Cap, Rotor,Wires, and a new S&B Cold Air Intake. Truck is getting detailed tomorrow so I might snap a few more pics, then on Sunday traveling down to the Florida Keys for 5 days to try and enjoy it before the oil spill demolishes the place for a while.

Anyways, here are some pics

Tonneau Cover



Trans Temp Gauge



Scangauge2









S&B intake





This intake is great, it is a true Cold Air Intake, as it draws cold air in from the fender well like the stock setup, but with a completley sealed box around the filter. Noticed quite a bit of power down low, and the same power from 3k rpm on up as the 14x3 had, it is also a lot quieter than the 14x3 and provides a nice deep sound at WOT.

 

Where did you get that cupholder on the end of your console? als owhat type of tranny temp gauge is that?

 

Check out genosgarage or ebay for the cupholder.Around 40 bucks or so.

 

how big was your trans temp sender?



but man very thing looks great!

 

Johnnyboy- As Mr. Freeze, stated, Geno's Garage, thats where I got the cup holder. And the gauge is an Autometer Z-Series gauge.

dodgeram07- Thanks buddy! And I believe this is the trans temp sender that I used.

http://www.summitracing.com/parts/ATM-2253/

 

looking nice man !

 

Some real nice additions
Good looking truck you got there

 

Thanks lastrights and RM, hopefully I can get the ol girl looking as good as both of yours one day!

 

Hmmm, I have never been a fan of steering wheel covers. But yours is very subtle and not even noticeable in the pics. It goes with the interior very well.

I think I might get one!!

 

How did you mod the shift ****? I've been trying to figure that out for weeks.