DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

replace plenum?

Thread Tools
 
Search this Thread
 
  #1  
Old 08-26-2010 | 11:16 PM
offroadjosh's Avatar
offroadjosh
Thread Starter
|
Record Breaker
Joined: Sep 2009
Posts: 2,072
Likes: 1
From: Montana
Default replace plenum?
Ok i have 200 bucks to spend right now. Should i spend it on the plenum and a tune up or something else? Im not getting any symptoms of a bad plenum...
 
Reply Like
  #2  
Old 08-26-2010 | 11:20 PM
J McWillis's Avatar
J McWillis
Professional
Joined: May 2010
Posts: 220
Likes: 0
From: Mesquite, TX
Default
That's 4 tanks of gas around here. Sounds like road trip time.
 
Reply Like
  #3  
Old 08-26-2010 | 11:21 PM
redseal's Avatar
redseal
Rookie
Joined: Dec 2009
Posts: 82
Likes: 0
From: winter haven, fl
Default
Put the money in the bank. Something will go wrong soon with the truck.
 
Reply Like
  #4  
Old 08-26-2010 | 11:32 PM
lastrights's Avatar
lastrights
Grand Champion
Joined: Sep 2007
Posts: 5,849
Likes: 4
From: the burgh
Default
i say save anohter 400 and get the airgap ! hehe or a sct tuner
 
Reply Like
  #5  
Old 08-26-2010 | 11:41 PM
CPTAFW163's Avatar
CPTAFW163
Champion
Joined: Jun 2004
Posts: 2,811
Likes: 2
From: Ft Campbell, KY/TN
Default
save it until you can do more than jsut the plenum and a tune up.
 
Reply Like
  #6  
Old 08-27-2010 | 12:24 AM
offroadjosh's Avatar
offroadjosh
Thread Starter
|
Record Breaker
Joined: Sep 2009
Posts: 2,072
Likes: 1
From: Montana
Default
Will do then! after i figure out my hard start issue lol. I think that might just be me needing a new cap and rotor...
 
Reply Like
  #7  
Old 08-27-2010 | 12:45 AM
CPTAFW163's Avatar
CPTAFW163
Champion
Joined: Jun 2004
Posts: 2,811
Likes: 2
From: Ft Campbell, KY/TN
Default
that is probably it. the summit one is a good buy. Summit cap has brass terminals. You might even be able to get an Accel cap/rotor from autozone. I run accel cap and rotors.
 
Reply Like

Trending Topics

  #8  
Old 08-27-2010 | 06:50 AM
dodge15004x45.9's Avatar
dodge15004x45.9
Legend
Joined: Nov 2008
Posts: 7,950
Likes: 2
From: Malvern Pa - Canadensis Pa
Default
Originally Posted by offroadjosh
Will do then! after i figure out my hard start issue lol. I think that might just be me needing a new cap and rotor...
Yea good luck with that one!!! If you find anything out call me and let me know!!
 
Reply Like
  #9  
Old 08-27-2010 | 08:36 AM
zje400ex's Avatar
zje400ex
Captain
Joined: Apr 2009
Posts: 521
Likes: 1
From: Ohio
Default
When I replaced my plenum gasket I replaced the cap and rotor too. Good luck getting to it It's not in a very easy spot to get to on these motors
 
Reply Like
  #10  
Old 08-27-2010 | 02:20 PM
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default
Originally Posted by offroadjosh
Will do then! after i figure out my hard start issue lol. I think that might just be me needing a new cap and rotor...

Could just be the fuel pressure regulator or leaky injectors. Is it hard to start always or when hot/cold or after it sits?
 
Reply Like



Advanced Search
Quick Reply: replace plenum?


Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 03:43 PM.