Yea just started this AM broke a intake manifold bolt somehow that cost me 3 hrs and then after that nothing went right. Where did u guys install your IAT sensor did u just cut a whole in the round filter? And how did your injectors fit mine dont seem to fit all the way in is that due to the new angle? My rockers were extremely clean as well as the valley under the manifold even the plenum was good. I didnt get around to getting pictures during but I got some before and ill do after.

 

i used runner hammer on my fuel rails, and put some oil on the o ringss

 

2 1/2", and 3"..

you should have the o/d and i/d, right?

I was expecting to have to break out the calipers and get you an accurate reading- but hell, it's 2.5" and 3" dead on..

 

I'll figure out the i/d and o/d. Thanks a lot drew. Much appreciated.