So i think im going to start tearing into my spare kegger this weekend, gonna clean the hell out of it and possibly start cutting.
ive read the dyi a few times and i just want to know where the best spot is to cut everything. it seems everyone has there own opinion on the matter, plus that thread is wayyyy too much reading lol.
i ordered the belly pan off ebay today, and ill be picking up the plenum gasket tomorrow. anything else i should do while im in there? anything i should pay special attention to? im not doing the install this weekend just getting the spare kegger ready. thanks in advance!

 

These threads should help.

https://dodgeforum.com/forum/2nd-gen...ghlight=Kegger
https://dodgeforum.com/forum/2nd-gen...ghlight=Kegger
https://dodgeforum.com/forum/2nd-gen...ghlight=kegger

 

I followed the DIY and cut mine very similar and no problems yet. My major concern was making sure the cuts are even and smooth. Good Luck

 

whats that thing? i didnt see it in any of the other threads.

 

Isn't that for the EGR?

 

no clue. this is the spare kegger i have. do you think mine has the same. this came off a 95 5.2 if i remember right i have the 5.9. and wtf do i do with it if mine is the same setup?

 

You probably can't do anything with it. And yours is a 95 so you have an EGR too. You need a 96 or 97, they dont have the egr valve , but they do have the two holes for temp senders.

 

what do i need to do to install the 96 or 97? does the truck need the egr?

 

Do you have emissions....if not I would sell that and pick up the intake from a 96/97

They wont have the egr port and then you can get rid of the egr setup all together, its not needed its just an emissions thing.

 

sweet! nope no emissions!