DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Need Help!

Thread Tools
 
Search this Thread
 
Old Jul 11, 2011 | 01:36 PM
Share
  #1  
haynes2159's Avatar
haynes2159
Thread Starter
|
Registered User
Joined: Jul 2011
Posts: 3
Likes: 0
Default Need Help!
The OBD2 wont read to be able to get my truck inspected and it also wont read on the code reader, the guy at the parts place can get it to read but by the time i get back to the inspection place it has stopped again. Any ideas?
 
Reply
0
Old Jul 11, 2011 | 01:39 PM
Share
  #2  
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default
One of the pins may be loose or a wire on the back of the port. I assume you/they tried jiggling it around?
 
Reply
0
Old Jul 11, 2011 | 01:41 PM
Share
  #3  
haynes2159's Avatar
haynes2159
Thread Starter
|
Registered User
Joined: Jul 2011
Posts: 3
Likes: 0
Default
Ya they tried wiggling it around. Is there a fuse that goes to the OBD2?
 
Reply
0
Old Jul 11, 2011 | 01:44 PM
Share
  #4  
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default
Not that I'm aware of.
 
Reply
0
Old Jul 11, 2011 | 01:49 PM
Share
  #5  
haynes2159's Avatar
haynes2159
Thread Starter
|
Registered User
Joined: Jul 2011
Posts: 3
Likes: 0
Default
Ok thanks I'm gonna try to pull the dash apart and check all the wires when i get off work? Hopefully I can get some answers there.
 
Reply
0
Back to Subforum
2nd Gen Ram Tech
View Next Unread
A/c not working!




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 09:04 AM.