Replacing the PCM stopped the stalling...Haven't changed the crank sensor...Local shop says probably the cam sensor.....We'll see...

 

Well I'm back ..Had an issue with my wife's Wrangler.You know what they say happy wife happy life...Now back to the Ram.
Starts good and runs good on the highway.
Idles with a little bit of a lope but takes off fine ( used to die when i would give it gas.PCM fixed that).Also replaced IAC,TPS,O2,Map and checked exhaust temp with gun averaged around 550 to 650 ..
No current codes..
What has me baffled now is idle.When rolling up to a stop the idle will drop to around 200 or die completely.If I keep it running with the gas pedal until a complete stop it will idle back to normal..Local shop says its the cam sensor makes sense for the lope but not the idle..
Don't remember who it was but someone posted about the wires getting cut on the speed sensor.I'll check that today..
Once again thanks for the help....

 

What brand sensors did you buy? The IAC for instance. And did you remove the negative battery cable before replacing any of the sensors?

 

Was buying BWD parts from Advance..Changed the Crank sensor today ( that was a pain).It was made wrong and hit the flywheel..Gettiing one from NAPA Monday...IAC is from BWD also may need to change it again...

 

The crank sensor fixed it..
Thanks for the help

 

Just my two cents, any time you throw sensors at these vehicles, use Dealer parts. Ecspecially something like a crank sensor. Advance auto is garbage. Napa is a little better. This is from my own experience.