truck wont start!!
#1
truck wont start!!
last night i changed the plenum gasket. big pain in the ***! well when i had everything but back together, my truck would not start... i put a fuel gauge on it and its getting fuel. i did the key cycle and it was showing cdes 11 and 12. 11 is No Distributor reference signal detected during engine cranking. Check the circuit between the distributor and PCM. and 12 is the battery disconnect. then 55 which is end of codes. any ideas?? i really need help!!
#2
#7
If you just changed the gasket, look forward to doing it again.....
Shouldn't have to pull the intake. Cam position sensor is in the dist. Harness runs behind the intake, where it is oh-so-easy to see...... may have trapped the wires..... ooops. If that look ok, check wires for crank position sensor as well. Find out which you are missing, spark, or injector pulse. That will tell ya which sensor is giving you fits.
Shouldn't have to pull the intake. Cam position sensor is in the dist. Harness runs behind the intake, where it is oh-so-easy to see...... may have trapped the wires..... ooops. If that look ok, check wires for crank position sensor as well. Find out which you are missing, spark, or injector pulse. That will tell ya which sensor is giving you fits.
Trending Topics
#9