2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

OMG what a shocker. The Big Boy didn't want to start

Thread Tools
 
Search this Thread
 
  #11  
Old 05-30-2013 | 10:07 PM
CatDumas's Avatar
CatDumas
Registered User
Joined: May 2013
Posts: 3
Likes: 0
Default

meow meow meowwwwww. This pic makes me hhhhhot, lol. Niiiiiice, sexy, front end and GREAT camera angle
 
  #12  
Old 05-30-2013 | 10:32 PM
CatDumas's Avatar
CatDumas
Registered User
Joined: May 2013
Posts: 3
Likes: 0
Default

Originally Posted by Big Lar
I had the Exact same thing happen to me about a year ago in my 97, ended up it was the Cam Sensor in the dist. Changed it out and it fired right up.

Larry
hmm. Prolly my problem as well. Its been on permanent (mostly) ignition relay kill due to the ATD disarm pattern being entered incorrectly by someone else. So for a year(cuz I'm super busy n can't find my wiring diagrams and haven't been stuck for more than 10 mins anywhere) I've had to do the alarm remote mating dance......arm disarm click arm disarm open door click arm disarm open door close door click......column shifter shuffle repeat.....arm disarm cuss a lot ....start. Can't find the model no of alarm box to get their diagram but I voltake checked all leads,fuses, etc n all good so I thot it HAD to be possibly a ground fault or lack of on wire to ignition from ATD but now I'm thinking that maybe Cam sensor is LYING to IGN kill just for kicks?

would I get the same scenario if so? No starter response, just click. I personally think it just misses me cuz I've not been driving it as much past 12 mos. Sometimes start 1st

try, sometimes I have to arange the cab floor litter in feng shue manner and then call a chinese fire drill. After we all buckle back in it starts. No rhyme or reason to the tricks I hafta play to get it to fire.
 
  #13  
Old 05-30-2013 | 10:40 PM
CatDumas's Avatar
CatDumas
Registered User
Joined: May 2013
Posts: 3
Likes: 0
Default

that's right smaartypantses..... I DID say I voltage checked all and then said I thot it was ground fault so I must be a silly girl. WRONG..... Didn't do check at starter motor or coil. I have tick infestation on property so bad I played the girl card n refused to get down under the truck. Coil check....well....er....em....I just actually forgot that step since it does spark after alarm box mating festivities so I opted out of the accidental electrocution clause.....

>°-'<
 
  #14  
Old 05-30-2013 | 10:44 PM
dodge dude94's Avatar
dodge dude94
Banned Goober Smoocher
Joined: Jun 2010
Posts: 8,916
Likes: 1
Default

Originally Posted by CatDumas
meow meow meowwwwww. This pic makes me hhhhhot, lol. Niiiiiice, sexy, front end and GREAT camera angle
Originally Posted by CatDumas
hmm. Prolly my problem as well. Its been on permanent (mostly) ignition relay kill due to the ATD disarm pattern being entered incorrectly by someone else. So for a year(cuz I'm super busy n can't find my wiring diagrams and haven't been stuck for more than 10 mins anywhere) I've had to do the alarm remote mating dance......arm disarm click arm disarm open door click arm disarm open door close door click......column shifter shuffle repeat.....arm disarm cuss a lot ....start. Can't find the model no of alarm box to get their diagram but I voltake checked all leads,fuses, etc n all good so I thot it HAD to be possibly a ground fault or lack of on wire to ignition from ATD but now I'm thinking that maybe Cam sensor is LYING to IGN kill just for kicks?

would I get the same scenario if so? No starter response, just click. I personally think it just misses me cuz I've not been driving it as much past 12 mos. Sometimes start 1st

try, sometimes I have to arange the cab floor litter in feng shue manner and then call a chinese fire drill. After we all buckle back in it starts. No rhyme or reason to the tricks I hafta play to get it to fire.
Originally Posted by CatDumas
that's right smaartypantses..... I DID say I voltage checked all and then said I thot it was ground fault so I must be a silly girl. WRONG..... Didn't do check at starter motor or coil. I have tick infestation on property so bad I played the girl card n refused to get down under the truck. Coil check....well....er....em....I just actually forgot that step since it does spark after alarm box mating festivities so I opted out of the accidental electrocution clause.....

>°-'<
What on earth are you talking about?
 
  #15  
Old 05-30-2013 | 11:52 PM
Darren270's Avatar
Darren270
Rookie
Joined: Apr 2012
Posts: 95
Likes: 0
From: Colorado
Default

What on earth are you talking about?
I've read these posts like 5 times already and I'm still not sure.
 
  #16  
Old 05-31-2013 | 01:16 AM
Paul DeHayes's Avatar
Paul DeHayes
Professional
Joined: Apr 2012
Posts: 173
Likes: 0
From: SC
Default

Originally Posted by Darren270
I've read these posts like 5 times already and I'm still not sure.
Must be "Peanut Butter Jelly Time" lmao!
 
  #17  
Old 05-31-2013 | 09:55 AM
CSDavies26's Avatar
CSDavies26
Veteran
Joined: Dec 2012
Posts: 487
Likes: 1
From: Evans City, PA
Default

Originally Posted by CatDumas
meow meow meowwwwww. This pic makes me hhhhhot, lol. Niiiiiice, sexy, front end and GREAT camera angle
that's right smaartypantses..... I DID say I voltage checked all and then said I thot it was ground fault so I must be a silly girl. WRONG..... Didn't do check at starter motor or coil. I have tick infestation on property so bad I played the girl card n refused to get down under the truck. Coil check....well....er....em....I just actually forgot that step since it does spark after alarm box mating festivities so I opted out of the accidental electrocution clause.....
hmm. Prolly my problem as well. Its been on permanent (mostly) ignition relay kill due to the ATD disarm pattern being entered incorrectly by someone else. So for a year(cuz I'm super busy n can't find my wiring diagrams and haven't been stuck for more than 10 mins anywhere) I've had to do the alarm remote mating dance......arm disarm click arm disarm open door click arm disarm open door close door click......column shifter shuffle repeat.....arm disarm cuss a lot ....start. Can't find the model no of alarm box to get their diagram but I voltake checked all leads,fuses, etc n all good so I thot it HAD to be possibly a ground fault or lack of on wire to ignition from ATD but now I'm thinking that maybe Cam sensor is LYING to IGN kill just for kicks?

would I get the same scenario if so? No starter response, just click. I personally think it just misses me cuz I've not been driving it as much past 12 mos. Sometimes start 1st

try, sometimes I have to arange the cab floor litter in feng shue manner and then call a chinese fire drill. After we all buckle back in it starts. No rhyme or reason to the tricks I hafta play to get it to fire.


....Cocaine's a hell of a drug
 



Quick Reply: OMG what a shocker. The Big Boy didn't want to start



All times are GMT -4. The time now is 06:57 PM.