ok I think i found the tps does it have to hex screws holding it on?if it is bad can i get a new one at advanced and how much would that part run me?and whats the best way to get the wire clip off without breaking it i notice mine has alot of dirt on it.thanks again

 

I thinnk they are torx.

 

ok thanks i should of typed torx and not hex but the 2 screws that hold the tps on are like these?http://www.psxboy.com/syssite/home/s...mg/big/743.jpg

if so then i found the right part just want to make sure before i check it this week.

 

That would be it.

 

i got another question I called advanced and auto zone the tps is $33.95 and like $66.95 for a tps with a life time warranty.then i called the dodge dealer and they have one made by dodge for $133.95 why so big of a price hike?my buddy tells me to get the one from the dealer cause they looked the part up by my vin number and it will be an exact match made by mopar.you think the $33.95 one from advanced is good enough or should i go buy the tps for $133.95 from the dealer?what one would you buy?does it really matter?

 

I'd go to NAPA and get the Delphi part for $68 or so. And yes, it matters if you care about how long you go before doing the job again.

 

also forgot to ask where is the maf located on my truck is it in the housing where the air filters located?I want to clean it and cant seem to find it.thanks...thanks ill try napa theres a napa a few towns away from me and see if they have a tps.

 

To me there are just certain things that should come from the dealer, and those are the sensor's for motors. Yes they are more money, I find that they work better than most parts store parts and they last longer as well. Everybody has there op on this it's your choice.

Pix of TPS and MAP

 

I don't know where Chrysler gets their stuff, but Delphi is an OEM supplier for several parts for several manufacturers. I've been using their aftermarket repair parts since the 1960's with never a complaint.

 

thanks for the pics that really helps.how do i go about cleaning the MAP? Do i remove it and spray it?what wire and connector the can of map cleaner said something about sprying the wires also never did this before so i dont wanna screw it up.also do you ever have to replace the map with a new one or can you jsut clean it?just wondering.