So i submerged my truck by accident in water up to plugs. Pulled it out changed oil changed plugs and wires now truck acts like it floods and keeps poping with no power not all the time but alot codes comming up O2 sensors well ive never had them hooked up please help i cant figure it out.

 

I figure that since you're running around without oxygen sensors, you've probably also got a compromised evac system, too, and probably pulled water into the fuel system that way.

If you encounter the fool who disconnected your oxygen sensors, whap him up side his hillbilly head with a shovel. That sort of fool should never be allowed anywhere near a motor vehicle except to get into the prison bus.

 

also check your transmission for water. they are not waterproof. there's a vent up in the top of the bell housing.

if you have water, change the pan fluid and flush the lines, cooler, torque converter and valve body asap, or it'll cost you a transmission.

popping noise sounds like firing out of time, caused by cam position sensor, crank sensor, or shorted out wiring harness. you may need to just give it time to dry out while you change fluid in transmission, tcase, front and rear diff.

what are your codes?

 

Only code showing up is O2 sensor code i already purchased all stuff for fluid change so i bought a new O2 as well

 

How do you accidentally submerge your truck up to the plugs? Haha but anyways I'd do like all these guys are saying change all the fluids and spray the spark plug wires, coil, and distributor with wd40 you might just have water in the coil or crappy insulation on some of your wires

 

Only code showing up is O2 sensor code i already purchased all stuff for fluid change so i bought a new O2 as well

 

New o2 all fix runs like new again

 

Until you decide to take her swimming again.....

 

And there goes another satisfied customer!

 

Lesson well learned i need a bigger lift thanks guys for the help it wasent my fault the river shouldnt been in the road