I have a 97 ram 4x4 5.9 with a 98 tranny..unknow miles but had been rebuilt at some point :/..anyhow It shifts sloppy from 1-2 but is otherwise great I adjusted the tv cable and man that's a pain I kinda went in blind and moved it back towards the firewall quite a bit and it helped. but the pan leaks and I'm going to weld a bung in for a temp probe and drain plug..I have read about the pressure adjustment. how do I do it? safe amount of turns and the out come? thanks.





Posted from Dodgeforum.com App for Android

 

Adjust your front band. Loosen the locknut on the adjustment screw, torque the adjustment screw to 72 lb/in with a lb/in torque wrench. Back it off 2 7/8 turns and hold it from turning while you tighten the locknut down to 30 ft/lbs. If you can't get a torque wrench on the locknut while holding the adjustment screw, just tighten it down good keeping 30 ft/lbs in mind.

 

ok,any auto parts stores (Napa,AutoZone,O'Reillys,farm and fleet,are my closest) carry a decent cheap wrench?


Posted from Dodgeforum.com App for Android

 

Just rent one from the parts store and when you return it they refund you the money.

 

I called and I can get one for 22 bucks,and what about line pressure? how many turns? or leave it?


Posted from Dodgeforum.com App for Android

 

The factory adjustment is in this thread, https://dodgeforum.com/forum/2nd-gen...-in-trans.html


And if you want to fool around with it after its back to stock. http://www.bionicdodge.com/Download/...Adjustment.pdf